Article Number 60874

Artificial Water XL 500 ml

500 ml, ready to pour out of the bottle

This product is suitable for scale
  • 1:22,5
  • 1:35
  • 1:43 (0)
  • 1:45
  • 1:50
  • 1:72
  • 1:76
  • 1:87 (H0)
  • 1:100
  • 1:120 (TT)
  • 1:144
  • 1:160
  • 1:200
  • 1:220 (Z)
  • 15 mm
  • 1:225
  • 28-32 mm
Note: Model building item
Warning Notice Attention:

Causes skin irritation.
Causes serious eye irritation.
Contains: 1,2 Benzisothiazol-3(2H)-on. May produce an allergic reaction.

€26.99 €53.98 / l Incl. 19% VAT, Excl. shipping
  •  Current delivery time approx. 4 - 7 working days
  •  No minimum order value

Artificial Water XL is ideally used for the creation of water surfaces on ponds, lakes and brooks.

Application: Paint the lake or creek bed with the NOCH Riverbed Colour Set (ref. 60875) or acrylic colours and let it dry well. The darker the colour, the deeper the water appears. After the colour has dried, the artificial water can be filled up to 2 – 3 mm high into the lake bed in one single cast. Hardening time is approx. 24 hours. While hardening, the artificial water loses approx. 50 % of its volume, so that a water level of 1 – 1,5 mm is achieved. Important: Several layers are not recommended as otherwise the lowest water layer can become cloudy!

  • Additional Information

    EAN 4007246608744
    Content 0.50 l
    Weight 565 g
  • How-to tip

    Water structuring is the biggest challenge in model landscaping. With NOCH products you have always a professional, yet the simplest possible solution at hand.
    Colour lakes, rivers and creeks with NOCH Riverbed Colour Set (ref. 60875) before starting to structure the water. Your colouring should become darker from the outside to the inside, as water appears darker with increasing depth. Fix small stones and sand on the shore surface to enhance this effect.

    Model water XL is particularly suitable for designing water levels on ponds, lakes and streams. Application: Paint the creek or lake bed with water base color set (item 60875) or acrylic paint and let dry well. The darker the color, the deeper the water. After the paint has dried, pour the model water into a cast approx. 2 - 3 mm high. Drying time approx. 24 hours. During curing, the model water loses about 50% of its volume, resulting in a water level of 1 -1.5 mm. Important: Further infusions are not recommended, as this can lead to clouding of the bottom water layer!

    »Waves & Billows« is a great new water product, with which you can finally form higher waves. The material is used with a spatula from the can and applied roughly on the dried water surface. After drying for about half an hour, it is hardy enough to design a higher surge. Model wonderful waves and water forms with a toothpick or a small spatula.

    The white spume often sets the crowning final of waves and rapids. NOCH »Foam & Spume« has been especially developed to recreate this great effect in model form. Apply »Foam & Spume« directly on the desired water spot with the user-friendly bottle and model it with a fine brush. A perfect finish for every water project!

You may also be interested in the following product(s)